Before You Begin A; Precautions A; Unpacking And Inspection A - Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation

Scorpion 240 Autoloader Installation Manual
Before you begin
Precautions
Caution. Observe the following precautions to avoid
•
•
•
•
Unpacking and inspection
Although Seagate autoloaders are inspected and carefully
packaged at the factory, damage may occur during shipping.
Follow these steps for unpacking the autoloader.
1. Inspect the shipping container. Notify your shipper
2. Place the shipping container on a flat, clean, stable
3. Save the drive container and packing materials in case
electrostatic damage to the internal autoloader.
Do not remove the drive from the antistatic bag until you
are ready to install it.
Before you remove the drive from the antistatic bag, touch
a grounded metal surface to discharge any static
electricity buildup from your body.
Hold the drive only by its edges and avoid direct contact
with any electronic components.
If you need to put down the drive, lay it on top of the
antistatic bag or place it inside the bag.
immediately if you find any damage.
surface. Then carefully remove the contents and verify
the packing list. If parts are missing or the equipment is
damaged notify your Seagate representative.
you ever need to ship the drive.
A-9