Installing The External Autoloader A; Configuring The External Scorpion 240 A - Seagate Scorpion 240 DDS-4 Autoloader Manuel D'installation

A-18
Installing the external autoloader
The external Scorpion 240 is a compact external drive that
connects to the host computer as a turnkey subsystem.
Installing the external drive involves three simple steps:
1. Configuring the drive
2. Connecting the SCSI interface cable
3. Connecting the power cord
Configuring the external Scorpion 240
The following is the default configuration for the external
Scorpion 240:
•
•
•
•
•
•
•
Setting the SCSI ID
Make sure that the drive is turned off; then set the SCSI ID for
the drive using the push-button switch on the back of the
external drive. Figure 6 on the following page shows this
switch, as well as the two SCSI interface connectors, on/off
switch, and the power-cord connector.
Note: The drive must be restarted for any change in SCSI ID
Scorpion 240 Autoloader Installation Manual
SCSI ID: 6
Media Recognition System (MRS) checking: enabled.
Parity checking: enabled.
Data compression: enabled.
Power-on self-test diagnostics: enabled.
Host operating system: Windows 95/98/NT/2000
Termination power: supplied to the SCSI bus.
to take effect.