Use And Maintenance; Warnings; Description Of The Warning Panel - Olimpia splendid MAESTR SMART Directives D'installation, D'utilisation Et D'entretien

3 - USE AND MAINTENANCE

3.1 - WARNINGS

The installation and electrical connection of the air conditioner should be carried out by specialized
personnel who possess the requisites set forth by law.
The installation instructions are contained in the appropriate paragraph of this manual.
No structural object (furniture, curtains, plants, leaves, blinds, etc.) should ever
obstruct the normal flow of air from either the internal or external gratings.
• Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious
damage to the external parts.
• Do not move the air outlet flap by hand. Always use the remote control to adjust baffle position.
• If the unit leaks water, switch it off immediately and disconnect it from the power mains. Call
the nearest service centre.
• When the air conditioner is heating, it has to periodically eliminate any ice that could form on
the external battery. While it is doing this, the machine keeps running but does not heat the
room. This lasts for a brief period of time, from 3 to a maximum of 10 minutes.
• Clean the air filter periodically, as described in the specific paragraph (2.6.1).
The air conditioner must not be installed in rooms where explosive gasses de-
velop or where there are conditions of heat and humidity beyond the maximum
limits indicated in the installation manual.

3.2 - DESCRIPTION OF THE WARNING PANEL

• G receiver for the remote control's communication signal. for proper operation this area requires a direct
line of sight to the remote control.
• LED D Green leD that indicates the unit is running. When the unit is in standby this light is off.
• LED C Yellow leD signals activation of the programming switch on and/or switch off.
• LED B Green leD that indicates the switching on of the cooling compressor.
• LED A Red LED that indicates the air filter may need cleaning.
• H Service micro-button (reSet). Used with a small round object, such as a paperclip to perform reset
functions.
B
G LED D LED C LED B LED A
USA - 14
H