EINHELL ESU 270 Mode D'emploi page 5

Anleitung ESU 270 12-sprachig 08.11.2001 11:05 Uhr Seite 5
GB
Note!
Always wear safety goggles and a
dust mask.
Always keep the dust extraction holes
in the vibrating plate free of dirt or
other obstructions.
Vibration measured according ISO
5349.
Special acessories
Sandpaper
Grain Packed in Art. no.
units of
40, coarse 10 44.602.10
60, medium 10 44.602.11
100, fine 10 44.602.12
In order to take full advantage of your
vibrating grinder, always use original
Einhell special accessories, available
at all hardware shops.
Attaching sandpaper
– Remove the plug from the mains
supply.
– Insert the end of the sandpaper and
close the clamping mechanism.
– Draw the sandpaper tigth over the
vibrating plate and clamp the other
end.
– Ensure that the holes match with the
vibrating plate.
Maintenance
– Always keep your vibrating grinder
clean.
– Do not use caustic cleaning agents
to clean the plastic housing.
– Check the carbon brushes is an
excessive amount of sparks is gene-
rated when working.
– Always keep the dust extraction
holes in the vibrating plate free of
dirt or other obstructions.
– Water must never come into contact
with the machine.
– The power supply cable must only
be replaced by a qualified
electrician.
5