Replacing The Battery On The Receiver - dB Technologies EME one Caractéristiques Techniques

Channel selection
To switch the channel turn the knob located on the receiver rear panel.
The two channels marked as "GUITAR MONITOR" cause the radio stage to we switched off, to
reduce consumptions and prolong the battery life.
For information about their use please refer to the application section.
ATTENTION
Should multiple systems be used in the same band, make sure that the receiver is tuned
in to the same channel as that of the desired transmitter.
Antenna
The antenna is made of a flexible material, for better use. Never cover the antenna when the unit
is in use.
Auxiliary audio input
This input allows to listen to any audio source through the headphones.
The signal always overlaps with the one sent by the transmitter. The signal on the auxiliary input
will always be present, even in case the transmitted signal should drop out.
In case of channel switching, audio will be mute for a few moments.
The input is equipped with a side switch, allowing to attenuate its volume.
The "phantom" power supply (5Vdc) is always present on the jack connector of the AUX input.
Please refer to the relevant section in the manual
ATTENTION
Insert the earpiece jack into the receiver socket before inserting the earpieces into your
ears.
Set the audio volume to the lowest level and gradually adjust the volume.
Sudden exposure to high-volume noises may damage your hearing system.
Depleted battery indication
Battery depletion is signaled by two events:
- The "POWER" LED turns from green to red
- A "beep" overlapping the audio is generated every 15sec.
Connections
Please refer to the relevant section in the manual
CAUTIONS
- Should the receiver remain unused for a prolonged time we recommend that you
remove the batteries to prevent possible damages due to leaks from the batteries.
- Use alkaline batteries
- Never use old batteries
- Make sure the receiver batteries are charged and in good working order
- Check that battery polarity complies with the indications found in the relevant
compartment

3.3. Replacing the battery on the receiver

- Slightly press the cover compartment (Fig. A).
- Fully open the cover (Fig. B)
- Insert or replace
compartment, paying special attention to the +/- polarities
specified on the bottom (Fig. C)
- Close the battery cover, paying special attention to
ensure that it is properly closed (Fig. D)
the batteries in the relevant
ENGLISH
16