Transmitter (Eme One-Tx); Controls And Functions - dB Technologies EME one Caractéristiques Techniques

2. TRANSMITTER
The EME-ONE system transmitter has 8 channels and
operates in the VHF band.
The transmitter operating frequency can be selected by
means of an 8-position switch located on the transmitter
front panel.
The antenna housed in the front panel must
be fully extended during use.
ATTENTION
The transmitter and the receiver must operate in the same channel and band.
The channel can be switched at any time, with the transmitter on or off.

2.1. CONTROLS AND FUNCTIONS

Front
1) "POWER" SWITCH
It allows to power the transmitter on and off.
2) "POWER" INDICATOR LIGHT
It is used to indicate two different operating modes
GREEN: normal operation
RED: channel switching under way
3) 8-position "CHANNELS" ROTARY SWITCH
It allows to select the desired tune-in channel ("0" lowest frequency - "7" highest frequency)
4) "INPUT 1" and "INPUT 2" SENSITIVITY CONTROL
It adjusts the sensitivity of the transmitter input signal, for the corresponding input.
This control doesn't affect the "LINK" output level
The knob controls both the microphone and line signal levels. Use the left knob for line-level
signals and the right one for microphone-level signals.
5) "PEAK" INDICATOR LIGHT
It is used to indicate the different operating modes of the corresponding input.
OFF: no input signal or audio level very low
GREEN: input signal present and audio level normal
YELLOW: input signal present and audio level high
RED: input signal present and audio level very high (peak)
The indicator glows red to signal the tripping of the internal limiting circuit,
preventing transmitter distortion and protecting the receiver against
overloads.
Avoid using the system for prolonged time with the indicator light steadily on
or flashing.
6) ANTENNA
The telescopic antenna allows signal transmission.
(EME ONE-TX)
ENGLISH
12