Receiver (Eme One-Rx); Controls And Functions - dB Technologies EME one Caractéristiques Techniques

Optimum transmitter usage
The EME-ONE system transmitter has a built-in two-channel audio mixer, allowing cross-mixing.
The quality of reception also depends on the signal levels applied to the transmitter input.
For this reason you should observe the following simple rules:
5. Set the knobs of the two audio inputs to the minimum level
6. Set the output signal of the mixer or of any other connected instrument to the highest
possible level
7. Adjust the input used for EME-ONE until the "PEAK" indicator lights only flash at peak time
and leave the unused input at the lowest possible level (fully turned anti-clockwise)
8. Switch on the receiver on the corresponding channel and set the audio volume to the desired
level
The procedure described above applies to all the instruments connected to the transmitter input.
Connections
Please refer to the relevant section in the manual
3.

RECEIVER (EME ONE-RX)

The EME-ONE system receiver has 8 radio channels, plus two channels
serving as monitors by disabling radio reception.
The receiver operating frequency can be selected by means of a 10-position
switch located on the receiver rear panel.
It is equipped with a spring for belt clipping.
ATTENTION
The transmitter and the receiver must operate in the same channel
and band.
The channel can be switched at any time, with the receiver on or off.

3.1. Controls and functions

ENGLISH
14