Receiver (Moving One-Rx); Controls And Functions - dB Technologies moving one B - 823-832 MHZ B6 UHF Mode D'emploi

2.

RECEIVER (MOVING ONE-RX)

The receiver of the system MOVING ONE operates in the UHF band, has a maximum of 77
channels, depending on the operating band, divided into 10 groups.
The selection of the transmission channel occurs by means of automatic selection or
manually.
It is possible to select the operating frequency of the receiver using buttons and the display
on the front.
The antennas housed on the front must be extracted for their entire length during
use.
ATTENTION
The transmitter and the receiver must operate in the same channel and in the same
band.
The channel can be switched at any time, with the transmitter on or off.

2.1. Controls and functions

Front
1) "POWER" BUTTON
Allows switching on and off the device. Press and hold the button. The display on the front of
the receiver turns on.
2) "SYNC" BUTTON
Pressing and holding the button for two seconds starts the procedure of timed
synchronization between transmitter and receiver.
3) "SYNC" LUMINOUS INDICATOR
It indicates the synchronization between the transmitter and the receiver
OFF:
FLASHING GREEN:
4) "IR"
Dedicated window for device communication via infrared (IR) with transmitters MOVING
ONE-TXH and MOVING ONE-TXB. Refer to the procedure specified below for details.
5) "GROUP" AND "CHANNEL" DISPLAY
Displays information about the group and the signal transmission channel.
6) "GROUP" BUTTON
Increases the group if pressed only once.
If pressed and held for 2 sec., starts the automatic scan of all groups.
7) "CHANNEL" button
Increases the channel if pressed only once.
If pressed and held for 2 sec starts the automatic scan of the free channels within the
selected group.
no synchronization
synchronization OK
ENGLISH
18