Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
-
Synchronize the receiver with the related transmitter and leave it on
-
Repeat the scan with the remaining systems and synchronize from time to time with the
relevant transmitters leaving them on once synchronized.
IMPORTANT
If you are in an area with an interfering source (e.g. digital TV) which occupies the entire
available bandwidth of the system, when scanning channel, it is selected the channel in
which the interference is lower.
Sometimes, in case of inconstant interferences, it is advisable to perform multiple scans
7.

CAUTIONS

"LARSEN" effect
The Larsen effect (also known as audio feedback) is an annoying sound generated when there
are any microphones which are too close to each other and are oriented toward the audio
speakers emitting the sounds picked by the microphones themselves. To avoid the Larsen effect
(which may damage the loudspeakers), we recommend that you leave a certain distance between
the microphones and the audio speakers; also lower the microphone volume (if needed) and don't
aim them at the audio speakers.
Induction-related phenomena
To prevent induction-related phenomena from generating buzzes and noise which compromise
proper system operation avoid placing the transmitters and receivers near equipment inducing
strong magnetic fields (e.g. power transformers, power conductors and lines powering the
speakers)
Drop outs
There area areas in which proper signal reception is difficult. To avoid drop outs you need to
move the receiver to a more appropriate location, avoid interposing any obstacles and, if needed,
reduce the distance between transmitter and receiver.
Place the receiver as far away as possible from the source of the disturbance, to avoid external
noises or unwanted sounds.
Batteries
-
If the transmitter is not used for a long time, it is recommended to remove the batteries
to avoid possible damage due to battery leaks.
-
Use alkaline batteries
-
Do not use old batteries
-
Make sure that the batteries of the receiver are charged and efficient
-
Make sure that the polarity of the battery is respected, following the signs into the
compartment
ATTENTION
Do not expose the batteries to excessive heat, sunlight, fire, or similar.
29
MOVING-ONE Diversity wireless microphone system

Publicité

Table des Matières
loading

Table des Matières