Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Operation
7.1
Add water to bowl
To add water to the toilet,
press the flush pedal part
way down. Water flows into
the bowl while flush ball
remains closed. If the flush
ball moves, let up on the
pedal slightly. Adding water
to an empty bowl helps pre-
vent holding tank odors from
entering the living space.
Adding water is recommended prior to flushing solids and toilet paper.
7.2
Flush toilet
To flush, press pedal down until it contacts the floor. Release pedal after
complete flush.
•
When flushing liquids, press the pedal for 1-2 seconds.
•
When flushing solids, press pedal until contents are rinsed from bowl.
Flushing longer than necessary will cause holding tank to fill too quickly.
A small amount of water will collect in the bowl after a flush to create an airtight
seal.
Note
Residual water trickle in ceramic bowls: Due to integrated rim of
models 310, 311, 320 and 321 toilets, water may continue to trickle
into toilet bowl for up to 20 minutes after flushing. If water trickle
continues after 30 minutes, replace water valve.
Note
To ensure holding tank odors do not enter the living space, make
sure 1 inch (24 mm) of water remains in the toilet bowl. Depending
on variations in plumbing systems and user operation, the "add
water" function may be required to achieve the 1-inch water depth.
Flush directions are located under
toilet seat lid.
Publicité
Table des Matières
