Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Digital Compact Equipment Manual for Swimspa
2.3.1 Installing the differential switch
The electrical installation should be fitted with a 2-pole, high sensitivity differential
switch in the general current input panel (the differential switch is not supplied with the
Spa).
ATTENTION – It is essential that the owner of the Spa checks and resets the
differential switch from time to time to check its good working order.
recommended to do this at least once a month.
Check that the differential switch is in the OFF position. Do not place the differential switch in the
ON position until the Spa is full of water.
2.3.2 Connecting the differential switch to the Kit.
Before doing any work on the kit, the electrical power supply should be switched off (differential
switch in the OFF position, or disconnect the cable from the mains).
Use a suitable cable depending on the place where the kit is to be installed and local applicable
laws, from the differential switch to the electrical cabinet of the kit. The cable section will be different
depending on the model of kit and the instance to the installation. The required kW are given in the
attached sheet entitled Electrical Specifications of the Kit.
To determine the section of the electrical installation leads, see the values given in the
aforementioned Electrical Specifications together with the following table:
6 – 11
m
11 - 15
m
15 – 20
m
For greater distances, increase the cable section proportionally.
OFF
GREEN
List of sections, distance and power required
2.1
2.5
2.8
3.2
Nominal section of the cable in mm
2.5
2.5
2.5
2.5
2.5
2.5
4
4
4
4
4
6
A differential
switch must be
installed
ON
RED
kW required
3.5
4,4
5,3
6,2
4
4
6
10
4
6
6
10
6
6
10
10
7
EN
It is
7,0
7,9
8,8
2
10
10
10
10
10
10
10
16
16
Publicité
Chapitres
Table des Matières
