Safety Warnings; General; Safety Warnings In Installation And Assembly Work; Safety Warnings In Maintenance Work - fluidra DIGITAL SWIMSPA Manuel De Fonctionnement

Digital Compact Equipment Manual for Swimspa

6. SAFETY WARNINGS

6.1. GENERAL

Avoid all contact with electrical voltage.
Follow all accident prevention regulations.
Any modification to the equipment requires the prior authorisation from the manufacturer.
Original spare parts and accessories authorised by the manufacturer guarantee greater safety.
The manufacturer of the equipment is exempt from all liability for damage caused by non-
authorised spare parts or accessories.
During operation, some parts of the equipment are at dangerous electrical voltages. Work on
elements or equipment connected to them should only be performed after switching off the
power supply and disconnecting the start-up devices.
The user should ensure that assembly and maintenance work is performed by qualified and
authorised persons, who have carefully read the installation and service instructions.
Safety in operating the machine can only be guaranteed by following and respecting the
installation and service instructions.
Maximum values are indicated in the electrical switchboard and should not be exceeded under
any circumstances.
In the event of a fault or breakdown, contact the Technical Assistance Service of the
manufacturer, or the nearest dealer of the manufacturer.
In this respect, the regulations of each country should be respected.

6.2. SAFETY WARNINGS IN INSTALLATION AND ASSEMBLY WORK

On connecting the electrical cables to the equipment, care should be taken regarding the lay-out
inside the connection box, check that pieces of cable do not remain inside and that the earth
conductor is properly connected.
Particular care should be taken that water does not, under any circumstances, leak into the
pumps or into the live electrical parts.

6.3. SAFETY WARNINGS IN MAINTENANCE WORK

Before performing any electrical or mechanical maintenance work, ensure that the power supply
to the machine is switched off and that start-up devices are blocked.
Do not handle the equipment with wet feet.
16
EN