Start-Up; Loading The Sand Filter - fluidra DIGITAL SWIMSPA Manuel De Fonctionnement

Digital Compact Equipment Manual for Swimspa

3. START-UP

Carefully read the following points before starting-up the Spa.
Once the whole installation has been assembled and before filling the sand filter, it is advisable to
start-up the system to check that all components work properly and that there are no leaks.

3.1. LOADING THE SAND FILTER

For maximum performance of the filter, it is recommended to use sand with a granulometry of 0.4 to
0.8 mm. The amount to use is indicated on the specifications plate of the filter.
To correctly fill the filter, follow the steps indicated below:
1. Remove the cover and the filter joint, taking care not to damage the joint.
2. Check that all collector arms are in good condition.
3. Carefully fill with water halfway.
4. Pour in the sand contents indicated on the label, taking care to protect the diffuser and avoiding
damage to the collector arms.
5. Remove the protection from the diffuser and place the cover, having first cleaned the sand and
waste from the closing area.
6. Fill the Spa with water.
7. Wash the filter so that it is ready for operation.
ATTENTION
During the filling process, ensure that water does not leak into electrical parts.
Sea water in the Spa will quickly lead to general deterioration of all components of the
circuit.
Do not fill the Spa will water warmer than 50ºC, as this may trigger the safety thermostat
and damage equipment and connections.
Once the Spa is full of water, connect the electrical equipment by placing the differential switch in the
ON position. (See Electrical Connection section).
Check that the differential switch works correctly. Press the test button and the differential switch
should automatically go from the ON position to the OFF position.
Do not use the Spa unless you have read the Spa Manual.
11
EN