Emptying The Spa; Very Important - fluidra DIGITAL SWIMSPA Manuel De Fonctionnement

Digital Compact Equipment Manual for Swimspa
The Automatic–Manual Selector should always be in the automatic position when the kit is
operating normally, otherwise the digital system will commit errors which could lead to
significant damage of the equipment.
The filter is the filtering element. Water passes through the sand which retains the particles. The
selector valve should be in the FILTERING position for the filter to operate.

4.3. EMPTYING THE SPA

The compact equipment can empty the Spa. To do this, follow these steps:
- Open the valves of the circuits that by-pass water to the drain.
- Turn off the Filtering Pump by placing the selector in the OFF position.
- Divert all the suction flow from the filtering pump to the drain, by closing the skimmer and bottom
cleaner valves and fully opening the drain valve.
- Place the selector valve in the EMPTYING position.
- Turn on the Filtering Pump by placing the selector in the Manual position.
- Once the Spa is empty, turn off the filtering pump by placing the selector in the OFF position and
disconnect the equipment from the power supply.
- To refill the spa, place the valves in their normal position.

VERY IMPORTANT

When the water level in the Spa is insufficient for the pump to suction water through the
sump, the pump should be turned off by placing the selector in the OFF position. Operating
the pump without water will cause significant damage. Emptying will continue through the drain.
13
EN