Dometic 103EAA Notice D'utilisation page 16

Operation
103EAB, 103EAC, 103EAD
➤ If you wish to switch between cooling and heating, press the
button "HOT/COLD".
I
NOTE
The control unit of the cooling device has a memory function.
It memorises the selected temperature range for each mode (cooling
and heating). Thus the temperature range which was previously
selected in the respective mode is set again with each switching on or
switching over.
✔ The red or blue operating display lights up and the device starts to cool/heat.
➤ When you want to finish the cooling or heating process, press the button "P".
➤ When you stop using the cooling device, disconnect it from the mains.
Selecting the temperature (103EAB, 103EAC, 103EAD)
6.8
The set temperature status display (fig. 4 5, page 4) indicates the selected
temperature. With an increasing number of illuminated LEDs, the cooling or heating
intensity also increases.
I
NOTE
The following temperature indications are subject to tolerances and are
dependent on the measuring position.
Temperature at interior space center at approx. 25 °C ambient temperature:
Status display
(fig. 4 5, page 4)
7 illuminated LEDs
Cooling
1 illuminated LED
7 illuminated LEDs
Heating
1 illuminated LED
➤ To select the cool or heat temperature, press the " " button repeatedly until the
desired number of LEDs are illuminated.
16
Interior temperature
approx 1 °C (TCX14)
approx 3 °C (TCX21, TCX35)
approx 17 °C (ECO mode)
approx 65 °C
approx 48 °C
EN