GE GFQ14 Manuel Du Propriétaire Et Instructions D'installation page 7

Getting started
Controls
J K
WASH SPIN DRY
Ex Heavy Ex Heavy Ex Hot Ex Hot Max Max
Door Lock
Heavy Heavy Hot Hot High High Off
Normal Normal Warm Warm Medium Medium Tumble
Light Light Cool Cool Low Low Low
Ex Light Ex Light Cold Cold No Spin No Spin Normal
Soil Temp Spin Dry
C D E
Display and Status Lights
The display shows cycle status (
cycle and the options selected. In addition, the display will show:
Door Lock
NOTE: If an out-of-balance condition is detected by the unit, the SPIN light will blink during the remaining portion of
the cycle and will stay illuminated for a short time after cycle completion. When this occurs, the unit is taking actions
to correct the out-of-balance condition and complete the cycle normally. In some cases, the unit may not be able to
balance the load and spin up to full speed. Run a Spin Only cycle.
A Power
Press to "wake up" the display. If the display is active, press to put the unit into standby mode.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
49-3000230 Rev 0
Time Extra
COOL
Saver Rinse
Est Time Remaining Est Time Remaining
Delay Ex Tumble
Delay
Wash Add Dry Time
Options
F G H L
WASH SPIN DRY
Controls locked on.
End of cycle signal on.
Door will lock from the start of the cycle until the end of the cool down phase.
B
Normal Auto Damp Dry
Delicates Auto Dry
Casuals
Whites
Heavy
Duty
Quick
Wash
Stain Wash
With Steam
Sanitize Tub Clean
), the Estimated Time Remaining until the end of the
COOL
I
Auto Extra Dry
Timed Dry
Start Power
Soak
Pause
Rinse + Spin
add a garment
Spin Only
A
7