GE GFQ14 Manuel Du Propriétaire Et Instructions D'installation page 27

Troubleshooting Tips... Before you call for service
Problem
Clothes take Improper sorting
too long to dry
Large loads of heavy
fabrics (like beach towels)
Non-venting unit
Controls improperly set
Blown fuses or tripped
circuit breaker
Overloading/combining
loads
Underloading
The Dry Load consists of a mixture
dryness level of heavy and light fabrics
was chosen
but load is still
damp
Control Controls accidentally put in
buttons not service mode
responding
Controls accidentally put in
lock mode
Controls performed an
incorrect operation
No numbers Unit is continuously
displayed monitoring the amount of
during cycle, moisture in the clothes
only lights
Time The estimated time may
Remaining change when a smaller load
jumped to a than usual is drying
lower number
Cannot make a The dryness Level, Temp or
selection and option that you are trying to
the unit beeps select is incompatible with
twice the chosen dry cycle
Unit is running The Ext Tumble option was
but 00 is chosen
displayed
in Time
Remaining
49-3000230 Rev 0
Possible Cause What To Do
Separate heavy items from lightweight items (generally, a
well-sorted washer load is a well-sorted dryer load).
Large, heavy fabrics contain more moisture and take longer to
dry. Separate large, heavy fabrics into smaller loads to speed
drying time.
Condensing dryers usually take longer to dry than a vented
dryer.
Match control settings to the load you are drying.
Replace fuses or reset circuit breakers. Since most dryers use
2 fuses/breakers, make sure both are operating.
Do not put more than one washer load in the unit at a time.
If you are drying only one or two items, add a few items to
ensure proper tumbling.
When combining heavy and light fabrics in a load, choose
Auto Extra Dry.
Press Start/Pause.
Hold the Soil and Temp buttons for 3 seconds to unlock the
unit.
Reset the in-house breaker.
This is normal. When the unit senses a low level of moisture in
the load, the unit will display the dry time remaining.
This is normal.
This is normal.
This is normal. During extended tumbling, the time remaining
is not displayed. The extended tumbling option lasts
approximately 60 minutes.
27