Delay Wash - GE GFQ14 Manuel Du Propriétaire Et Instructions D'installation

Getting started
H
Delay
Wash
I
Start
Pause
J
Soil Temp
K
Temp Spin
L
Add Dry Time
12

Delay Wash

Use to delay the start of your unit.
1. Choose your wash cycle and any options.
2. Press Delay Wash pad. You can change the delay time in 1-hour increments (up to
24 hours) each time you press the Delay Wash pad. Stop pressing the pad when your
desired time is displayed.
3. Press the Start/Pause button to start the countdown.
The countdown time will be shown in the Est Time Remaining (Estimated Time Remaining)
display.
NOTES:
• If the door is opened while the unit is in Delay Wash, the countdown time will stop the
count down and the display will show "door". The door must be closed and the Start/Pause
button must be pressed to continue the delay time count down.
• You can delay the start of a wash cycle up to 24 hours.
The light on the pad will light up when Delay Wash is on.
Start/Pause
Press to start a wash cycle. If the unit is running, pressing it once will pause the unit and
unlock the door. This function can be used to add garments during a cycle. Press again to
restart the wash cycle.
NOTE: If the unit is paused and the cycle is not restarted within 15 minutes, the current
wash cycle will be cancelled.
NOTE: In some cases the unit will drain first, then unlock the door when it is paused.
NOTE: The unit performs automatic system checks after pressing the Start/Pause button.
Water will flow in 45 seconds or less. You may hear the door lock and unlock before water
flows; this is normal.
Lock
You can lock the controls to prevent any selections from being made. Or you can lock or
unlock the controls after you have started a cycle.
Children cannot accidentally start the unit by touching pads with this option selected.
To lock the unit, press and hold the Soil and Temp pads together for 3 seconds.
To unlock the unit controls, press and hold the Soil and Temp pads together for 3 seconds.
A sound is made to indicate the lock/unlock status.
The control lock icon on the display will light up when it is on.
NOTE: The Power button can still be used when the unit is locked.
Signal
When the light is on, the unit will beep at the end of the cycle and every time you press a
pad on the control panel.
To turn the signal off, press and hold the Temp and Spin pads together for 3 seconds.
A sound is made to indicate the lock/unlock status.
Add Dry Time
Press the up and down arrow pads to increase or decrease the Dry cycle time as desired.
49-3000230 Rev 0