Setup / Settings - Delta SOLiViA 3.3 Manuel D'utilisation Et D'installation

6.10

Setup / settings

The default display language for solar inverters leaving the Delta factory is set to English.
After connecting to correct DC voltage and running through self-test, you will be asked to specify
the network ID and to select the desired country (see § 7.3.8.2) (countries available: Belgium,
Czech Republic, France, Germany, Greece, Italy, Portugal, Spain and United Kingdom).
The selection has to be confi rmed another time by the user. Once confi rmed, the network ID and
the country selection are stored to the controller memory – and the solar inverter is ready for
operation.
Please note that the enter keys on the display are locked, if there is no input entry within 5
minutes. To unlock the enter keys, you need to switch off the DC voltage and then switch it on
again.
Country selection
Enter network ID
Up *
Increase network ID
* Timeout if no key is pressed (within 5 minutes)
Please note, that once the country has been selected and confi rmed, it is only possible to change
the country by following the steps as listed below:
1. Please click ESC +
2. Provide the key code to the Solar Support Team at support@solar-inverter.com to get the PIN
code (valid for one use only!).
3. Once you get the PIN code, you need to press ESC +
4. Then, you will be asked to insert the PIN code and to confi rm it twice.
5. After confi rmation, you will then be able to select the desired country.
Note: These steps must be executed without interruption. Otherwise, you will stay in the country
selection mode.
Operation and installation manual SOLIVIA 3.3 EU G3
ENTER *
Down *
Decrease network ID
Up *
Next country
for few seconds to get the key information.
ESC *
Select country
Down *
ENTER *
Country before
.
Possible countries:
Belgium
Czech Republic
France
French island (60 Hz)
Germany
Greece continent
Greece island
Italy (50 Hz / 49 Hz)
Italy (51 Hz / 49 Hz)
Portugal
Spain (51 Hz / 49 Hz)
Spain (51 Hz / 48 Hz)
United Kingdom
Normal mode
17