Tectro TBH 570-3 Manuel D'utilisation page 152

4
152
man_TBH570-3-TBH572-3 ('21) V1.indd 152 man_TBH570-3-TBH572-3 ('21) V1.indd 152
Poor quality fuel can generally be recognised as follows:
- different diameter than the required 6 mm and/or various diameters
- varying lengths, higher percentage of shorter pellets
- the surfaces exhibit vertical and/or horizontal cracks
- high dust content
- dull surface
- floats in water
Poor fuel may result in:
- poor combustion
- frequent blocking of the combustion chamber
- increased pellet consumption
- low heat output and low efficiency
- soot on glass
- more ash and unburnt granules
- higher maintenance costs
Even when good, standardised pellets are used, it is not unusual for
G
there to be differences in the combustion speed, ash production and
build-up of debris. If a different type of pellet is used to the ones used
during commissioning, the stove must be set up again by a Tectro-
approved service technician.
G
Store and transport the pellets in absolutely dry conditions. Wooden
pellets can expand considerably when they come into contact with
water.
Contact the Tectro sales person or approved Tectro fitter for more information
about pellets.
5.2 FILLING THE PELLET HOPPER
Open the cover of the pellet hopper on top of the stove and carefully empty the
pellets into it to until 3/4 full. Make sure that no pellets fall into the stove. Close
the cover again.
Never touch any rotating parts in the pellet hopper. To avoid the risk
of coming into contact with rotating parts in the pellet hopper, it is
recommended that you always completely switch off the stove by
removing the plug from the power socket.
If the hopper needs refilling during operation, make sure the pellets and/
or pellet bag cannot come into contact with the hot parts of the stove
as this could lead to dangerous situations. Make sure never to touch any
rotating parts in the pellet hopper.
13-07-2021 13:38 13-07-2021 13:38