Keypad Function - Klein Tools VDV Scout Pro 3 Manuel D'utilisation

ENGLISH
Use for cable location identification mapping and/or continuity testing. Self-storing remotes display
on tester as Remote ID #1.
FRONT
RJ11/12 port
QUICK-REFERENCE
• VOICE / UP BUTTON
terminated cable, toggles selection upward in other modes.
• VIDEO BUTTON : Performs continuity test on F-terminated coax cable.
B
• DATA / DOWN BUTTON
terminated cable, toggles selection downward in other modes.
• TONE / HUB BLINK BUTTON
tone cadences, initiates Hub Blink.
• SETTINGS BUTTON
enters Length Constant Edit mode.
• LENGTH BUTTON F
• POWER / BACKLIGHT BUTTON
IN DETAIL
• VOICE / UP BUTTON
Test mode, the first short press selects Voice mode, repeated short presses selects wires or pairs of wires. Long press:
Turns Loop mode on or off. When in Tone or Length Test mode, returns to home screen. When in Settings mode,
changes UOM from feet to meters, or increases the length contant value.
• VIDEO BUTTON B : Short Press: Initiates continuity test on an F-terminated coax cable. When in Tone or Length Test
mode, a short press selects Video mode. Long press: Turns Loop mode on or off. When in Tone or Length Test mode,
returns to home screen.
• DATA / DOWN BUTTON
Short Press: Initiates wiremap test on RJ45 terminated cable. When in Tone or Length Test mode, first short press
selects Data mode, repeated short presses select wires or pairs of wires. Long press: Turns Loop mode on or off.
When in Tone or Length Test mode, returns to home screen. When in Settings mode, changes UOM from feet to meters,
or increases the length contant value.
• TONE / HUB BLINK BUTTON
Long press: Initiates Hub Blink. NOTE: DO NOT attempt to use Hub Blink function when connected to a Power over
Ethernet (PoE) active port.
• SETTINGS BUTTON E
adjust value). Default for Length Constant mode is the wire pair of pins 1 and 2 of data/RJ45 cable, and the wire pair
of pins 3 and 4 of voice/phone cable. See LENGTH CONSTANT section for more details. Second short press: Displays
option of feet or meters (use the UP
details. Long press: Exits Settings mode and returns to home screen.
• LENGTH BUTTON
F
By default, the test will initiate on the first wire with no faults found. See LENGTH MEASUREMENT and LENGTH
CONSTANT sections for more details.
• POWER / BACKLIGHT BUTTON
the backlight on and off. Press the power button a second time to turn the LCD backlight on or off.
Long press: Turns unit off. NOTE: Unit will automatically power off after 5 minutes of inactivity, or after 60 minutes
when in Tone mode.
SELF-STORING TEST + MAP™ ID REMOTE (VDV510-210)
RJ45 port
A : Performs wiremap test on RJ11/RJ12
: Performs wiremap test on RJ45
C
D : Cycles through available
: Selects feet or meters,
E
: Measures cable length.
G : Turns unit on or off, turns backlight on or off.
: Short Press: Initiates wiremap test on RJ11/RJ12 terminated cable. When in Tone or Length
A
C :
D : Short Press: Repeated short presses will toggle through available tone cadences.
: Short Press: Enters Length Constant edit mode (use the UP
and DOWN
A
: Short Press: Initiates cable length test. Test will default to a cable connected to the RJ45 port.
: Short Press: First short press turns unit on, repeated short presses will turn
G
BACK

KEYPAD FUNCTION

buttons to change). See LENGTH MEASUREMENT section for
C
F-connector port
A B
D
E
G
A and DOWN
C
F
C buttons to
3