General Specifications - Klein Tools VDV Scout Pro 3 Manuel D'utilisation

The Klein Tools VDV Scout
troubleshoots RJ11, RJ12, RJ45, and F-connector terminated cables and provides tone generation
for cable tracing. The VDV Scout
blink testing, and traces up to 19 locations (up to 5 locations with included remotes, additional
remotes available separately).
Dimensions: 6.5" x 3.0" x 1.6" (16.5 x 7.6 x 4.1 cm)
•
Weight: 11 oz. (312 g) with battery and remote
•
Operating Temperature: 32° to 122°F (0° to 50°C)
•
Storage Temperature: -4° to 140°F (-20° to 60°C)
•
Humidity: 10% to 90%, non-condensing
•
Maximum Voltage (between any two connector
•
pins without damage):
- RJ Jack: 66V DC or 55V AC
- F-Connector: 66V DC or 55V AC
To ensure safe operation and service of the tester, follow these instructions. Failure to observe these
warnings can result in severe injury or death.
The VDV Scout Pro 3 is designed for use on unenergized cabling systems. Connecting the VDV Scout
®
•
to live AC power may damage it and pose a safety hazard for the user.
Improperly terminated RJ plugs have the potential to damage the jacks on the VDV Scout
•
inspect an RJ plug before inserting it into the tester. The contacts should always be recessed into the plastic
housing of the plug. Plugging 6-position plugs into the 8-position jack on the tester has the potential to
damage the outer-most contacts of the jack unless the plug is specifically designed for that purpose.
Warning or Caution
Always wear approved eye protection.
Conformité Européenne. Conforms with European Economic Area directives.
This symbol indicates that equipment and its accessories shall be subject to a separate
collection and correct disposal.
RJ45 Port: Data cable, Ethernet cable, Cat5e, Cat6, Cat6a, Cat7, Cat7a.
F-Connector Port: Video cable, coaxial cable, RG6/RG6Q cable, RG59 cable.
RJ11/12 Port: Voice cable, POTS (plain old televoice service) cable, 4-wire cable, 6-wire cable,
2 twisted pair cable, 3 twisted pair cable, Cat3.
VDV SCOUT
RJ45 port*
F-connector port
*The RJ jacks share internal connections so only one RJ cable can be connected at a time for accurate cable
test results. However, an RJ cable and a coax cable may be connected at the same time. In ID mode, all
connectors on the VDV Scout
2
ENGLISH

GENERAL SPECIFICATIONS

Pro 3 is a portable voice-data-video cable tester. It tests and
®
Pro 3 also measures cable length, tests for shield, performs hub
®
SYMBOLS ON TESTER
PORTS AND REMOTES OVERVIEW
PRO 3 TESTER
®
RJ11/12 port*
Pro 3 may be connected at the same time.
®
Battery Life (9V alkaline):
•
- Standby: 4 years
- Active: 50 hours (without backlight)
Cable Types: Shielded or unshielded; Cat7a, Cat7,
•
Cat6a, Cat6, Cat5e, Cat3, Coaxial
Length Measurement Method: Capacitance
•
Length Measurement Range:
•
1.5 ft to 1,999 ft. (0.5 m to 610 m) with 15pF/ft
Length Accuracy: (5% ft.) or (5% m)
•
Length Constant Range:
•
10pF/ft. to 40pF/ft. (33pF/m to 132pF/m)
WARNINGS
Do NOT use on energized circuits.
Read instructions
Use for cable location identification mapping.
Included in kit or sold separately.
LanMap™
Location ID Remote**
VDV526-055
RJ45
connector
**Cannot be used to determine continuity.
Barrel Connector
VDV814-609
Female-to-female F-connector
Use with F-connector port
Pro 3. Visually
®
LOCATION ID REMOTES
CoaxMap™
Location ID Remote
VDV512-056
F-connector
CONNECTORS
Pro 3
®