auna Belle Epoque Mode D'emploi page 20

• To turn the system ‚on', press the POWER button on the front panel 1 second, and set the volume to a
low level. The POWER indicator lights up.
• Press the function selector buttons (MW/UKW/CD/USB/T APE/PHONO) to select your desired function.
• Start to adjust the volume by using the VOLUME control.
• When you have finished your listening, press the POWER button 3 seconds to turn off the unit. The
POWER indicator goes off.
• Press the CD/USB button first and the FUNCTION button second to enter USB mode, the ‚- - -' and USB
icon will be shown.
• Insert a USB device into the USB socket. The player will begin to MP3 icon will be shown while MP3
is detected.
• Press PLAY/PAUSE button to start or pause playback of the selected track in the CD/USB mode.
• PLAY/PAUSE, DN/F .R/UP/F .F and STOP functions are the same as in CD play mode.
You may press the FUNCTION button on the unit or the PLAY/P AUSE button on the remote control to
change the playing mode between CD and USB.
• Turn the system on, press the FUNCTION button to enter CD mode.
• Press the OP/CL button to open the CD drawer.
• Place your disc (MP3 is comptiable) in the CD drawer with the label side facing up.
• Press the OP/CL button again to close the CD drawer. The disc will spin for a few seconds while the
player is reading the disc, then the disc stops spinning and start to play the first track of the disc.
• MP3 icon will be shown while MP3 is detected. No icon will be shown when no MP3 file is detected in
the disc.
PLAYING IN MP3 MODE (UNDER CD/USB OPERATION)
• Press PLAY/PAUSE button to start or pause playback of the selected track in the CD/USB mode.
• While playing the song, the song number and folder number of you.
• You can stop the playback at any time by pressing the STOP button.
20
Operation
Power On
USB
CD