Vertical Ironing - DOMENA CR3 ecofibres Manuel D'instructions

Table des Matières

Publicité

GERÄUSCHE
Um
eine
gleichmäßige
gewährleisten, ist Ihr Bügelgerät mit einer Pumpe
ausgestattet. Diese macht sich bemerkbar, sobald Sie
die Dampftaste des Bügeleisens drücken. Unter
gewissen Bedingungen hört man sie deutlicher:
- bei der ersten Inbetriebnahme
- wenn der Wassertank leer ist
- bei jedem Austauschen der Kalkfilter-Kartusche.
Während des Betriebs ist das Surren der Pumpe
normal.
VERTIKALES BÜGELN
• Das Eisen kann bei vertikalem Bügeln auch senkrecht
gehalten werden, um hängende Kleidung oder
andere Textilien zu glätten.
28. Dabei das Bügeleisen von oben nach unten führen
und mehrmals die Dampfstoßtaste drücken.
• Am besten das zu dämpfende Stück glatt gespannt
halten. Die Bügelqualität hängt von der Art des
Gewebes ab.
DAMPFSPRAY
Ihr Bügeleisen ist mit einer Dampfspray – Funktion aus-
gestattet. Sie wird eingesetzt zum Befeuchten von
"schwierigen" Textilien und zur Beseitigung von hart-
näckigen Knitterfalten.
Benutzung der Dampfspray – Funktion
Die Dampfspray – Funktion kann nicht
benutzt werden
- während der Benutzung des "Eco"-Modus
- während der Aufheizzeit, solange die
Temperatur-Kontrolllampe des Dampf-erzeu-
gers nicht erloschen ist.
29. Während des gesamten Spray – Vorgangs die
normale
Dampftaste
gleichzeitig die Spray – Taste drücken. Der
Dampfspray funktioniert so lange wie Sie die
Spraytaste gedrückt halten.
Dampfleistung
zu
gedrückt
halten
und
NOISE
To ensure regular steam output performance, your unit
is equipped with a pump which is activated each time
the steam trigger is pressed. It is loudest when there is
no water in the system e.g.:
- the appliance is used for the first time
- the water tank is empty
- the anti-scale cartridge has just been changed.
During normal use the pump has a gentle humming
sound.

VERTICAL IRONING

• Your iron can also be used vertically to steam
clothing on hangers or curtains in situ etc.
28. Move the iron from top to bottom, keeping the
steam button pressed. For best results, the material
to be steamed should be taut.
• The results vary according to the type of fabric.
STEAM SPRAY
The iron has a steam spray facility which permits the
use of a higher level of dampness to deal with creases
but without leaving any water marks which would take
longer to dry off.
Using the spray
The spray cannot be used when
- the ECO mode is in use
- when the appliance is heating up from
cold and the generator pilot light is still on.
29. Press the steam trigger in the normal way and at the
same time push the spray button for as long as
required. The jet of steam will carry on as long as
the spray button is pushed.
- 25 -

Publicité

Table des Matières
loading

Table des Matières