Kundendienst; After-Sales Service - DOMENA CR3 ecofibres Manuel D'instructions

Table des Matières

Publicité

KUNDENDIENST

Grundsätzlich ist der Händler, bei dem Sie dieses
Gerät erworben haben, Ihr erster Ansprechpartner.
Darüber hinaus stehen Ihnen diverse autorisierte
DOMENA Service-Partner zur Verfügung.
Eine entsprechende Liste dazu finden Sie auf der
DOMENA-Homepage
"http://www.domena-gmbh.de"
Tel. 0721/9333941 bzw. Fax 0721/9332942.
Da das Dampfbügelsytem aus zwei separaten Einheiten
(Bügeltisch bzw. Dampfstation) besteht, muss nur die
jeweilige Einheit zum Händler gebracht werden.
Trennen der Dampfstation vom Bügeltisch:
44. Lösen Sie das Dampfkabel aus den Clips.
A. Ziehen Sie die Kabelführung leicht nach oben.
B. Drehen Sie die Kabelführung (Vierteldrehung).
C. Stecken Sie sie aus der Dampfstation.
45. Heben Sie die Abstellfläche hoch, um die
Befestigungsknöpfe der integrierten Dampfstation zu
erreichen.
Montieren Sie die Dampfstation ab, indem Sie die
zwei schwarzen Knöpfe abschrauben. Die
Dampfstation gleitet aus dem System.
46. Montieren der Dampfstation.
Befestigen Sie die Dampfstation wieder an
dem Bügeltisch, indem Sie sie stark gegen den
Bügeltisch schieben und schrauben Sie sie an.
unter
HYPERLINK
oder
unter

AFTER-SALES SERVICE

Your appliance can be repaired by any authorised
Domena service dealer. For easy servicing it is not
necessary to send/take the entire ironing centre to the
service dealer.
To detach the steam hose support :
44. Remove the clips
A. Lift up the support
B. Turn it a quarter turn
C. Remove it completely from the unit
To replace the hose support, carry out this procedure in
reverse.
44. Lift out the iron rest unit completely in order to
access the screws that secure the whole unit to the
table. Unscrew these and the unit disengages
from the table.
46. Reaffixing the iron/generator
unit
Reconnect by pushing the whole unit firmly in
at the bottom and putting the screws back in.
- 33 -

Publicité

Table des Matières
loading

Table des Matières