Bügeln Mit Dampf; Eco Function - DOMENA CR3 ecofibres Manuel D'instructions

Table des Matières

Publicité

BÜGELN MIT DAMPF
Dampfstoßtaste drücken, um Dampf
zu erhalten.
Wenn kein Wasser mehr im Tank ist,
sollte die Dampfstoßtaste nicht mehr
betätigt werden.
Tipps
• Dank der hohen Dampfleistung braucht die
Dampstoßtaste jeweils nur kurz gedrückt zu werden.
Kurzes,
wiederholtes
Dampfstoßtaste
genügt,
ausreichende Menge Dampf zu erhalten.
• Bei intensivem Gebrauch kann nach dem Loslassen
der Dampfstoßtaste noch Dampf austreten, und
Wassertröpfchen können auf der Abstellfläche
erscheinen, was normal ist, da der verbleibende
Dampf auf ihr kondensiert. Falls nötig, die Platte
abtrocknen. Es besteht keine Gefahr, dass sie
Schaden nimmt.
• Stellen Sie den Dampfmengenregler auf die Mitte
der Dampfskala
- bei der ersten Inbetriebnahme,
- wenn der Wassertank leer ist,
- bei jedem Austauschen der Kalkfilter-Kartusche.
ECO - MODUS
Für wenig zerknitterte oder leichte Wäsche oder
Wäsche aus dem Wäschetrockner empfehlen wir
Ihnen, Ihr Gerät im ECO-Modus zu benutzen
(genügende, aber sparsame Dampf- und Heizleistung).
So sparen Sie bis 50 % Strom und 70 % Wasser
gegenüber der vollen Dampfleistung.
22. Um den ECO-Modus zu benutzen, drücken Sie den
e
Schalter "
". Die Kontrolllampe bestätigt diese
Wahl.
Drücken
auf
die
um
ständig
eine
GENERATION OF STEAM
Press the steam button to obtain
steam.
Never call for steam when there is
no water in the reservoir.
Please note
• Because of the high steam output rate, there is no
need to continually press the steam button. Pressing
the button briefly and frequently will enable you to
control the quantity of steam, in order to obtain
professional results. It also prolongs the life of your
anti-scale cartridge.
• If the iron is used intensively, steam may continue to
be produced after the steam button has been
released and water may appear on the iron holder.
This is normal and is caused by condensation of
steam droplets. Sponge them off if necessary. There
is no risk of the metal being damaged.
• You should turn the steam output dial to the middle
setting when
- the unit is used for the first time,
- the water tank has been refilled,
- the anti-scale cartridge has just been changed.

ECO FUNCTION

It is recommended that you use the ECO function when
the garments are only slightly creased, have come out
of a tumble dryer and whenever you think suitable. In
this way you will be obtaining maximum economy in
the use of water and electricity, up to 50% in electricity
and 70% in water.
22. To use the Eco mode, press the button marked
The illuminated pilot light will confirm that this mode
is operational.
- 21 -
e
.

Publicité

Table des Matières
loading

Table des Matières