Rega FONO MM MK5 Mode D'emploi page 2

EN www.rega.co.uk
1. INPUT
2. OUTPUT
3. TURNTABLE EARTH
4. AC SOCKET
POWERING UP
The Fono MM is turned on by pressing the
on-off button located on the front, when the
unit is active the Rega logo will glow RED.
WARNING: We advise you to turn the Fono
on first, followed by the amplifier. This
is because the power surge in the Fono
could cause an audible, power on "thump"
which may distress the speakers.
1 2
METHOD OF CONNECTION
INPUT: Connect the tonearm leads and
earth (if used) to the input socket and to the
earth terminal on the back of the Fono.
TURNTABLE EARTH: If the turntable or tonearm
has a separate signal earth connection,
this should be connected to the turntable
earth terminal on the back of the unit.
OUTPUT: Connect the output socket of the
Fono to the line input on the amplifier.
PLEASE NOTE: If you have an integrated
amplifier with built in phono stage, DO
NOT connect the Fono to this input.
POWER SUPPLY: Connect the Rega PS1 to
the AC socket on the Fono back panel.
3 4