Targa CR 1.0 A1 Manuel D'utilisation Et Informations Sur Les Services page 33

3. Press the + (18) or – (17) button several times to select the "Playback" function.
4. Press the OK button (12) to enable the playback function.
Further information can be found in the "Playback" section on page 25 and in "The playback
menus" section on page 37.
FlashLight
Thanks to your Dashboard Camera's 4 white LEDs (8), the device can also be used as a flashlight.
How to switch the 4 white LEDs (8) on or off:
1. Power the Dashboard Camera on by pressing and holding the On/Off button (14) for approx.
3 seconds.
2. If the Dashboard Camera is connected using the car charger, press the Return button (16) to
display the main menu. Otherwise, continue with step 3.
3. Press the + (18) or – (17) button several times to select the "FlashLight" function.
4. Press the OK button (12), select the desired option by pressing the – button (17) and then
press the OK button (12) to confirm:
Off: Turns the flashlight function off.
Always Bright: Turns the flashlight function on.
One Second Flash: Turns the flashlight function on. The 4 white LEDs (8) then flash once a
second. This mode saves the battery.
If you have enabled the "Auto Power Off" option in the "Setup" menu, the flashlight will
also power off after the set time.
Setup
The setup menu contains basic settings for your Dashboard Camera. These include date and time,
idle time before automatic shutdown (power-saving function), key press confirmation sound, on-
screen menu language, image rotation, formatting function for the inserted SD memory card,
factory settings restore and firmware version information.
Setting
Date/Time
Auto Power Off
Description
Set the date and time (see also "Setting the date/time" on page 19).
You can set the device to power off automatically after a certain time
to save power. If no buttons are pressed during the preset time, the
device powers off automatically. The Dashboard Camera can then be
switched on again using the On/Off button (14).
CR 1.0 A1
English - 31