Before You Start; Inserting/Removing The Memory Card; Car Mount - Targa CR 1.0 A1 Manuel D'utilisation Et Informations Sur Les Services

Before you start

Inserting/removing the memory card

You will need a microSD memory card (not included) to save your photos and
videos. If a memory card is inserted, all the content recorded is saved onto it. If
no memory card is inserted, recording will not be possible. In this case the message
"PLEASE INSERT SD CARD" will appear. Confirm by pressing the OK button (12).
Proceed as follows to insert a memory card:
WARNING!
memory card.
Only use Speed Class 6 or faster memory cards.
If you have not inserted a microSD memory card the message "PLEASE INSERT SD
CARD" will appear when the device is switched on.
1. Open the protective cover (4) on the left--hand side of the Dashboard Camera.
2. Insert the memory card with the contacts facing towards the front of the device (towards the
display (13)) into the microSD card slot (2) until it clicks in place.
3. Close the protective cover (4) on the left--hand side of the Dashboard Camera.
To remove the memory card, gently press on the inserted card. The memory card will protrude a
little so that you can get hold of it and remove it.

Car mount

The car mount allows the Dashboard Camera to be
mounted on the windscreen of your vehicle.
1. Connect the Dashboard Camera to the car mount. To
do this, screw the thread for the car mount (9) on to the
car mount's threaded pin (22). You can use the knurled
nut (23) to fix the Dashboard Camera in place.
2. Then press the suction pad (24) of the car mount
against the windscreen and secure by pressing down the lever (26).
Power the Dashboard Camera off before you insert or remove a
CR 1.0 A1
English - 15