Charging The Battery - Targa CR 1.0 A1 Manuel D'utilisation Et Informations Sur Les Services

CR 1.0 A1
As the thread for the car mount (9) is located at
the top of the Dashboard Camera, you should
install the car mount such that the Dashboard
Camera "hangs" off it (see adjacent image).
Otherwise the controls (10 to 20) will be upside
down.
DANGER!
the operating area of the vehicle's airbag and install the car mount so that the driver's
view is not obstructed.
3. Loosen the knurled screw (27) to line up the Dashboard Camera in the desired position with
the help of the ball joint. Re-tighten the knurled screw (27).
4. To remove the car mount from the windscreen, flip the lever (26) up again and then pull on
the release tab (25) on the suction pad.

Charging the battery

The Dashboard Camera battery can be charged via the USB port on a computer or with the car
charger supplied.
In addition to the options below, you can also connect the Dashboard Camera to an
external USB power adapter (not supplied) and charge the Dashboard Camera that
way. You can purchase a suitable 5V USB power adapter with at least 1A output
current from any electronics retail outlet.
WARNING!
easily accessible wall outlet so that it can be disconnected quickly in case of an
emergency.
16 - English
Do not install the car mount (with or without the Dashboard Camera) within
When using an external power adapter, it must be connected to an