Menus; Main Menu - Targa CR 1.0 A1 Manuel D'utilisation Et Informations Sur Les Services

Menus

The Dashboard Camera has various menus that provide various settings for the different modes.
There is also a setup menu allowing you to set the preferences for your Dashboard Camera.

Main menu

In the main menu you can access the desired recording function, playback function and the Setup
menu for your Dashboard Camera. There is also a flashlight function available here so that the
Dashboard Camera can be used as a light in the dark.
1. Power the Dashboard Camera on by pressing and holding the On/Off button (14) for approx.
3 seconds.
2. If the Dashboard Camera is connected to the car charger, press the OK button (12) to stop
recording and then the Return button (16) to show the main menu. Otherwise, continue with
step 3.
3. Press the + (18) or – (17) button several times to select the desired function.
4. Press the OK button (12) to enable the selected function.
The available functions are described in the sections below.
Loop recording
Loop recording is a function in which video clips of a certain length (e.g. 5 minutes) are recorded.
After that recording time, a new video file is automatically created. As you record videos, the
optional microSD memory card fills up. Once the storage space has been used up, the oldest
video in the current recording is automatically overwritten. This ensures that recording is always
possible, even when the storage space has actually all been used up.
In this mode, you should ensure that any recordings you wish to keep are either protected (see
"Protecting videos from being overwritten during loop recording" on page 23) or transferred to a
different storage medium (e.g. your PC, see "Transferring recordings to a computer" on page 39).
1. Power the Dashboard Camera on by pressing and holding the On/Off button (14) for approx.
3 seconds.
2. If the Dashboard Camera is connected using the car charger, press the Return button (16) to
display the main menu. Otherwise, continue with step 3.
3. Press the + (18) or – (17) button several times to select the "Loop recording" function.
4. Press the OK button (12) to enable loop recording.
CR 1.0 A1
English - 29