Product Identification - CAMPAGNOLA Starberry MD 2 Manuel D'utilisation Et D'entretien

3.1

Product identification

A CE identification plate / label is applied to each machine / tool (Picture 1).
Model, serial number and year of manufacture are shown on the Manufacturer's CE plate. The CE plate is applied
on the machine / tool and shows the following data and symbols:
1) Compliance marking according to the 2006/42 / CE directive.
2) Company name and full address of the Manufacturer / Constructor.
3) Mandatory prescription for all personnel being responsible for the use and / or maintenance of the machine / tool
as per the corresponding use and maintenance manual.
4) Machine / tool designation.
5) Type of machine / tool - Designation of the type / code of the machine / tool.
6) Serial number.
7) Year of construction, i.e. the year in which the manufacturing process was completed.
8) Information pursuant to the 2012/19 / EU "WEEE" Directive: Electric and electronic waste may contain substances
that are dangerous for environment and human health. Therefore, they must not be disposed of with the household
waste. They must be carried to a waste collection center to be collected separately.
9) Power supply voltage of the tool (only for battery-operated tools).
For a correct and clear identification of the tool, reference must be made to type, serial number and year of con-
struction shown on the identification plate. Mention them to Campagnola Srl for any request for intervention or
assistance.
The CE marking is unique and certifies the compliance of the product with the machinery directive and other
applicable directives according to the conditions prescribed and reported in this manual.
In the case of a "composite" machine / tool, a CE plate / label is attached to the product and a label in sticked on
the tool to identify the type of tool (eg. ATRA.xxxx) constituting the composite machine / tool
The customer is responsible for verifying the integrity of the CE plate / label.
The user is required to replace the CE plate and / or the warning plates which, due to wear, have become illegible.
It is absolutely forbidden to remove the plates / labels from the machine / tool. Campagnola S.r.l. declines all
responsibility for the safety of the machine / tool if this prohibition is neglected.
The machine plate is positioned as shown in the picture below.
Pag. 22
Picture 1
Use and Maintenance Manual – Original
Instructions Rev.: 01, Date 25/01/2022