Product Identification; Product Description - CAMPAGNOLA STAR 40 Manuel D'utilisation Et D'entretien

Product identification

A CE identification plate / label is applied to each machine / tool (Picture 1).
Model, serial number and year of manufacture are shown on the Manufacturer's CE plate. The CE plate is applied
on the machine / tool and shows the following data and symbols:
1) Compliance marking according to the 2006/42 / CE directive.
2) Company name and full address of the Manufacturer / Constructor.
3) Mandatory prescription for all personnel being responsible for the use and / or maintenance of the machine /
tool as per the corresponding use and maintenance manual.
4) Machine / tool designation.
5) Type of machine / tool - Designation of the type / code of the machine / tool.
6) Serial number.
7) Year of construction, i.e. the year in which the manufacturing process was completed.
8) Information pursuant to the 2012/19 / EU "WEEE" Directive: Electric and electronic waste may contain sub-
stances that are dangerous for environment and human health. Therefore, they must not be disposed of with
the household waste. They must be carried to a waste collection center to be collected separately.
9) Power supply voltage of the tool (only for battery-operated tools).
For a correct and clear identification of the tool, reference must be made to type, serial number and year of
construction shown on the identification plate. Mention them to Campagnola Srl for any request for interven-
tion or assistance.
The CE marking is unique and certifies the compliance of the product with the machinery directive and other
applicable directives according to the conditions prescribed and reported in this manual.
In the case of a "composite" machine / tool, a CE plate / label is attached to the product and a label in sticked
on the tool to identify the type of tool (eg. ATRA.xxxx) constituting the composite machine / tool
The customer is responsible for verifying the integrity of the CE plate / label.
The user is required to replace the CE plate and / or the warning plates which, due to wear, have become
illegible. It is absolutely forbidden to remove the plates / labels from the machine / tool. Campagnola S.r.l.
declines all responsibility for the safety of the machine / tool if this prohibition is neglected.

Product description

The pneumatic shear may only be used on fixed or telescopic extension pole made of aluminum or carbon.
The pneumatic shears with a sharp knife (4), tempered steel, is intended to be used for pruning of orchards, olive groves,
citrus groves and ornamental plants for street furniture. The cutting blade power is provided by a pneumatic cylinder
inside a the body (2) made of thermoplastic resin, driven by compressed air line by means of an operating lever (3) in
the tool hand grip. The protection (6) protects your hands from knocks and the tool from accidental activation. The lever
(3) has a safety catch (5) that automatically engages upon release thereof.
The tool has been designed and manufactured exclusively for the purposes mentioned above.
Pag. 22
Picture 1
Use and maintenance manual – Translation of
original Instruction Rev.: 01, Date 10/11/2021