SilverCrest SBT 1.5 A1 Mode D'emploi page 32

1) Remove the shaving head
and cleaning the shaving head".
2) Press the parts of the cutting head out towards the open side of
the shaving head housing
3) Clean the individual parts carefully under running water.
4) Leave the parts to dry thoroughly.
5) To re-assemble, insert the cutting head cover
head housing
cover slide into the catches on the inside of the cutting head
cover (see fig. 1).
SBT 1.5 A1
as described in the section "Removing
.
so that the indentations on the cutting head
Fig. 1
into the shaving
GB │ IE │
29 ■