Safety Regulations - Stiga MULTICLIP 50 RENTAL Mode D'emploi

CG MCPt/Sti 171503915/1
EN

SAFETY REGULATIONS

TO BE FOLLOWED CAREFULLY
A) TRAINING
1) Read the instructions carefully. Get familiar with the con-
trols and proper use of the equipment. Learn how to stop the
engine quickly.
2) Only use the lawnmower for the purpose for which it was
designed, i.e. for cutting grass. Any other use can be haz-
ardous, causing damage to the machine.
3) Never allow children or people unfamiliar with these instruc-
tions to use the lawnmower. Local regulations may restrict the
age of the operator.
4) Never use the lawnmower:
– When people, especially children, or pets are nearby.
– If the operator has taken medicine or substances that can
affect his ability to react and concentrate.
5) Remember that the operator or user is responsible for acci-
dents or hazards occurring to other people or their property.
B) PREPARATION
1) While mowing, always wear sturdy footwear and long
trousers. Do not operate the equipment when barefoot or
wearing open sandals.
2) Thoroughly inspect the area where the equipment is to be
used and remove all objects which may be thrown by the
machine or damage the cutter assembly and the engine
(stones, sticks, metal wire, bones, etc.)
3) WARNING: DANGER! Engine fuel is highly flammable:
– Store fuel in containers specifically designed for this purpose.
– Refuel using a funnel and outdoors only. Do not smoke
while refuelling or whenever handling the fuel.
– Add fuel before starting the engine. Never remove the cap of
the fuel tank or add fuel while the engine is running or when the
engine is hot.
– If fuel is spilled, do not attempt to start the engine but move
the machine away from the area of spillage and avoid creating
any source of ignition until the fuel has evaporated and the
vapour dispersed.
– Replace all fuel tanks and containers caps securely.
4) Substitute faulty silencers.
5) Before use, always inspect the machine, especially the
condition of the blades, and check that the screws and cut-
ting assembly are not worn or damaged. Replace worn or
damaged blades and screws in sets to preserve balance.
C) OPERATION
1) Do not operate the engine in a confined space where dan-
gerous carbon monoxide fumes can collect.
2) Mow only in daylight or good artificial light.
3) If possible, avoid operating the equipment in wet grass.
4) Always be sure of your footing on slopes.
5) Walk, never run and do not allow yourself to be pulled along
by the lawnmower.
6) Mow across the face of slopes, never up and down.
7) Exercise extreme caution when changing direction on
slopes.
8) Do not mow on slopes of more than 20°.
9) Exercise extreme caution when pulling the lawnmower
towards you.
10) Stop the blade if the lawnmower has to be tilted for trans-
portation when crossing surfaces other than grass, and when
transporting the lawnmower to and from the area to be mowed.
11) Never operate the lawnmower with defective guards.
20
28-12-2006 11:23 Pagina 20
12) Do not change the engine governor settings or overspeed
the engine.
13) On power-driven models, disengage the drive clutch before
starting the engine.
14) Start the engine carefully, following the instructions and
keeping feet well away from the blade.
15) Do not tilt the lawnmower when starting the engine. Start
the engine on a flat surface that is free of obstacles and tall
grass.
16) Do not put hands or feet near or under rotating parts.
17) Never pick up or carry a lawnmower while the engine is run-
ning.
18) Stop the engine and disconnect the spark plug wire:
– Before carrying out any work underneath the cutting deck;
– Before checking, cleaning or working on lawnmower;
– After striking a foreign object. Inspect the lawnmower for
damage and make repairs before restarting and operating the
lawnmower;
– If the lawnmower starts to vibrate abnormally (find and
remove the cause of the vibration immediately).
19) Stop the engine:
– Whenever you leave the lawnmower unattended. Remove the
key from models with electric starters.
– Before refuelling.
– Before adjusting the cutting heigh.
20) Reduce the throttle before turning off the engine and turn
the fuel off when you have finished mowing, following the
instructions in the engine handbook.
21) When mowing, always keep to a safe distance from the
rotating blade. This distance is the length of the handle.
D) MAINTENANCE AND STORAGE
1) Keep all nuts, bolts and screws tight to be sure the equip-
ment is in safe working condition. Regular maintenance is
essential for safety and performance.
2) Never store the equipment with fuel in the tank inside a
building where vapour may reach a flame or a spark or a source
of extreme heat.
3) Allow the engine to cool before storing in an enclosed space.
4) To reduce the fire hazard, keep the engine, exhaust
silencer, battery compartment and fuel storage area free of
grass, leaves, or excessive grease. Do not leave containers
with grass cuttings in rooms.
5) If the fuel tank has to be drained, this should be done out-
doors and when the engine is cool.
6) Wear strong work gloves when removing and reassembling
the blade.
7) Keep the blade balanced during sharpening. All opera-
tions on the blade (dismantling, sharpening, balancing,
remounting and/or replacing) require a certain familiarity and
special tools. For safety reasons, these jobs are best carried
out at a specialized centre.
8) For reasons of safety, do not use the equipment with
worn or damaged parts. Parts are to be replaced and not
repaired. Use genuine spare parts (blades should always
bear the symbol ). Parts that are not of the same quality
can damage the equipment and be dangerous for your
safety.
E) TRANSPORTATION AND HANDLING
1) Whenever the machine is to be handled, raised, transported
or tilted you must:
– wear strong working gloves;
– grasp the machine at the points that offer a safe grip, taking
account of the weight and its distribution.
– use an appropriate number of people for the weight of the
machine and the characteristics of the vehicle or the place
where it has to be placed or collected.