Nieaf-Smitt Solar EazyPV Mode D'emploi Rapide page 21

Solar
ATTENTION:
Always ensure that the circuit under test is electrically isolated from
the mains supply before attempting an earth resistance measurement.
ATTENTION:
Do not leave the EazyPV permanently connected to a PV installation.
Always disconnect all testleads immediately after use.
WARNING DANGER:
It is not allowed to remove, to skirt or to tide over the enclosure or
safeties of the tester, during operation.
WARNING DANGER:
It's forbidden to place and/or to use the EazyPV in a room where
there is a risk of explosion.
ATTENTION:
If the tester is used by a third party, you being the owner are
responsible, unless otherwise specified.
ATTENTION:
Mors Smitt B.V. reserves the right to, without prior notice, update the
software in the EazyPV, which is returned for either reparation or
other reasons.
WARNING DANGER:
Repair can only be done by Mors Smitt B.V.
WARNING DANGER:
It's forbidden to execute measurements if strong electrostatic or
electromagnetic fields are present.
TIP:
Contact Mors Smitt B.V. if you require information concerning training
regarding the EazyPV solar tester.
Tel.: +31 (0)30 – 2881311 (general) www.nieaf-smitt.com
www.nieaf-smitt.com
21