Attaching The Power Switch Cover - Epson TM-T88V Manuel D'utilisateur

English

Attaching the Power Switch Cover

The enclosed power switch cover ensures that the power switch is not pressed
accidentally.
You can turn on and off the power switch by inserting a sharp-pointed object in
the holes in the power switch cover. To detach the cover, use a sharp-pointed
object.
To use this cover, install it as shown in illustration M on page iv.
WARNING:
If an accident occurs with the power switch cover attached, unplug the AC
cable immediately. Continued use may cause fire or shock.
Changing the Paper Width
If a roll paper guide is included with your printer, you can change the paper
width from 80 mm to 58 mm by installing the roll paper guide. Follow the steps
below to change the paper width.
CAUTION:
If you once change the paper width from 80 mm to 58 mm, you cannot
change it back to 80 mm.
When changing the paper width, be sure to make the setting for the paper
width with utility software for the TM-T88V.
1. Open the roll paper cover.
2. Install the roll paper guide so that the projection on its bottom is aligned with
the hole at the right of the roll paper holder, as shown in illustration N on
page v.
3. Tighten the enclosed screw to fix the roll paper guide.
4. Paste the enclosed 2 strips along the roll paper guide on the bottom of the roll
paper holder, as shown in illustration O.
Make sure the space between the top edge of strip and the line of the groove
in the roll paper guide (indicated as a in the illustration) is 0.5 mm or less.
5. Install the roll paper correctly.
6. Close the roll paper cover.
Troubleshooting
No lights on the control panel
Check whether the DC cable and AC cable are correctly connected to the printer
and the power outlet.
Error LED on with no printing
❏
Check whether the roll paper cover is closed. If it is open, close it.
❏
If the Paper LED is on, check whether the roll paper is correctly installed and
any roll paper remains.
6 TM-T88V User's Manual