Adjust The Length Of The Cutting Line; Adjust The Length Of The Cutting Line Manually; Operation Tips; Cutting Tips - GreenWorks STF305 Manuel D'opérateur

EN
8.4 ADJUST THE LENGTH OF THE
CUTTING LINE
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
3. Resume trimming.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
8.5 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
1. Stop the machine.
2. Push the spool retainer button (17) and pull on cutting
line to manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it again.
NOTE
NOTE
NOTE
English
8.6

OPERATION TIPS

Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep a firm hold with the two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
8.7

CUTTING TIPS

• Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris from hitting the operator.
• Do not cut in the danger area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
8
WARNING
WARNING