Line Cut-Off Blade; Change To The Edging Mode; Pivoting Head Function; Maintenance - GreenWorks STF305 Manuel D'opérateur

DANGER
AREA
BEST CUTTING
AREA
8.8

LINE CUT-OFF BLADE

This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
8.9

CHANGE TO THE EDGING MODE

You can change the trimmer to an edger to keep patios,
driveways and sidewalks well groomed.
1. Stop the machine.
2. Push on the edge button and turn the trimmer head 90
degrees until the trimmer head locks into position.
3. Release the edge button (8).
90°
DIRECTION OF
ROTATION
NOTE
English
8.10

PIVOTING HEAD FUNCTION

Adjust pivoting head to trim areas which are hard to reach
and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until the
trimmer head locks into required position.
3. Release the pivoting button (14).
9

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
9.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
9
NOTE
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
EN