Safety Warnings - S&P TLS-601 Mode D'emploi

ENGLISH
INSTRUCTIONS FOR USE
Please read these instructions carefully before starting the convector heater as they provide important
information for your safety and for the correct use of the convector heater.
Please check that the convector heater is in perfect condition when you unpack it as any factory defects are
covered by the S&P guarantee.

SAFETY WARNINGS

.- Before connect the convector, make sure the power supply
corresponds to the details shown on the nameplate.
.- Before connect the conector, make sure that the rotative switch is in 0
position.
.- The convector should not be placed in a location recessed (under a
table, desk..etc) where it interferes with the free circulation of air, both
in the input and the output.
.- The convector must not be placed directly below a power point.
.- Do not use this convector close to a bath, shower or swimming pool.
.- Do not handle the convector with wet hands.
.- To disconnect the unit from the socket-outlet, not pull from the power
cable.
.- Before performing any operation of cleaning and maintenance, ensure
that the appliance is disconnected from the power supply.
.- Whilst the convector is in operation, the cable must not be in contact
with the hot area of the device.
.- Do not use the convector to dry clothes.
.- Do not insert any object into any of the grids of the convector, as it
could cause an electrical shock, start a fire or break the device.
9
9