Safety Warnings - S&P TLS-501 Notice D'utilisation

ENGLISH
ENGLISH
INSTRUCTIONS FOR USE
Please read these instructions carefully before starting the convector heater as
they provide important information for your safety and for the correct use of the
convector heater.
The TLS-501 and TLS-503 Turbo convector heaters meet the European electrical
safety regulations. The accessories required for assembly, mobile device or fixed
device, are indicated in Figure 2.
Please check that the convector heater is in perfect condition when you unpack it
as any factory defects are covered by the S&P guarantee.

SAFETY WARNINGS

.- The convector must not be placed directly below a power point.
.- Do not use this convector close to a bath, shower or swimming pool.
.- Whilst the convector is in operation, the cable must not be in contact with the
hot area of the device.
.- Do not use the convector to dry clothes.
.-. Do not handle the convector with wet hands.
.- This symbol means "Do not cover" this appliance with objects that
prevent the air circulating freely. Obstructing the airflow increases the risk of
overheating.
.- If the flexible power cable is damaged, it should only be replaced in one of our
Repair Workshops or by qualified staff in order to avoid a dangerous situation.
.- Double insulated appliance , therefore does not require grounding.
.- If the convector is installed permanently, the minimum distances indicated in
Fig. 3A must be respected.
.- Do not place the convector next to a wall made of combustible materials
(wood, plastic, etc.).
.- Inflammable objects must not be left within 50 cm of the hot air circuit
(curtains, etc.).