Safety Instructions - S&P HET-1800 Mode D'emploi

ENGLISH
RADIANT FAN HEATER – HET-1800
Please read these instructions carefully before using the product in order to avoid
damage or any dangerous situations arising. Any use of the product other than that
indicated in this manual may cause fire, electrical danger, or injury and will make the
warranty null and void.
The warranty does not cover any defect, deterioration, loss, injury, or damage that is due to
incorrect use of the product. All legal rights in this regard are guaranteed. No warranty condition
can exclude or change the warranty conditions regulated by State laws that may not be
excluded or modified for any reason.
Before doing anything else, remove the packaging carefully and check the integrity of the
product. Should any defects or damage be found, do not install or attempt to repair the
equipment, but contact the dealer.
Do not leave the packaging within reach of children and dispose of the parts in compliance with
current provisions.
1. The product
 Description of the product (Figure 1):
A Radiant fan heater HET-1800 model
B 2 x carbon lamps 900W
C Control panel
D Base
E Remote control with 2 x Batteries AAA 1.5V model
 Along with the equipment you have bought, the pack also contains:

4 x screws

1 x Allen key

1 x Installation manual and instructions for use
Should any part be missing, contact your dealer.
2.

Safety instructions

Make sure the power supply corresponds to the details

shown on the nameplate: 230 V ~ 50Hz.
This product has been designed as a mobile heater.

Flammable objects (curtains, furniture, plants, etc. ) should

not be placed at less 3 meters from the appliance. The
front of the appliance must be free of objects.
The unit can operate in the outside, if always is covered.

8