Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Attach Top Mounting Bracket
1. With the rim of a mounting bracket pointing down, align the holes
in the bracket with the top pair of slots in the back panel.
2. Working from the back, insert two carriage bolts through the
bracket and back panel as shown.
A
A. Carriage bolts
B. Bracket rim
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut.
4. Slide the bracket to the very top of the slot and fully tighten the
nuts.
Attach the Middle and Bottom Mounting Brackets
1. With the rim of a mounting bracket pointing down, align the holes
in the bracket with the top pair of slots located in the middle
section of the back panel.
2. Working from the back, insert two carriage bolts through the
bracket and back panel.
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut. Hand tighten only, as this bracket will need to be
adjusted to mount the cabinet on the wall.
4. Repeat above steps to attach bottom mounting bracket to the
lower section of the back panel.
IMPORTANT: Fully tighten the nuts on the middle and bottom
brackets after mounting the cabinet to the wall, See "Mount the
®
Cabinet to GearWall
Panels or GearTrack
Mount the Cabinet to GearWall
GearTrack
IMPORTANT:
Be sure the GearWall
®
panels or GearTrack
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
If GearTrack
®
channels will be used to support the Gladiator
GearBox cabinet, they must be installed 18" (46 cm) apart.
18" (46 cm)
B
®
Channels."
®
Panels or
®
Channels
®
channels are
NOTE: The two nuts on the middle and bottom mounting brackets
must be loose enough to allow the brackets to move in the slots on
the cabinet.
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall
GearTrack
®
channels.
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
3. Using two or more people, engage the top bracket into the slot
by lifting up, pushing toward the wall and lowering the bracket
rim into the slot as shown.
4. Make sure the top bracket is fully engaged in the slot as shown.
A
A. Bracket rim
B. Slot
5. Open the cabinet doors.
6. From inside the cabinet, grasp the bolts in the middle bracket
and adjust the bracket until it aligns with the slot in the GearWall
panel or GearTrack
7. Push the cabinet toward the wall and lower the middle mounting
bracket into the slot.
8. Make sure the middle bracket is fully engaged in the slot as
shown.
9. Repeat for the bottom bracket.
10. Using a ¹⁄₂" wrench, fully tighten the nuts attaching the middle
and bottom mounting brackets.
®
Tall
WARNING
Excessive Weight Hazard
B
C
C. Bracket fully
engaged
®
channel.
®
panels or
®
3
Publicité
Table des Matières
