Mount The Panels; Complete Installation - Gladiator Garageworks GEARWALL 8 Instructions D'installation

Mount the Panels

IMPORTANT: Start at one of the bottom corners of the desired
coverage area and work toward the other in horizontal rows.
1. Mark the lowest edge for the GearWall
level chalk line at this height. It is recommended for this chalk line
to be at least 12" (30.5 cm) from the floor.
2. Measure from the starting edge of the desired coverage area to
the center of the last wooden stud that is within 8 ft (2.43 m).
3. Cut the first panel to this length, making sure the cut is square.
NOTE: Panels shorter than 24" (60.96 cm) long should not be
used.
4. Place the panel above the horizontal chalk line applied in Step 1.
Align the panel with both the starting edge and the horizontal
chalk line. Panels are installed with the interlock tongue up and
the groove down.
5. Check that the panel is level. Then place a screw in every slot at
every stud location.
NOTE: Drive the screws through the slot groove until they are
flush. If splitting occurs, predrill and countersink the drill holes
near the channel end.
6. Continue this process until you reach the opposite edge of the
desired coverage area.
7. Then start a new row, remembering to stagger the panels if
necessary. See the "Panel Location Requirements" section.
8. Continue in this manner until the desired coverage area is
complete. Periodically, check that the panels are level. It is
4
®
installation by snapping a
recommended that the upper edge of the final row of panels be
12" (30.5 cm) below the ceiling.
A
9. The final row of panels can be rip cut lengthwise to fit the
required height.
10. Begin additional walls in the same manner as the first, starting
with the corner that meets the completed wall. Be sure to align
the panel slots.
For a trimless installation, place new panels snugly against
■
the existing panels.
For a trimmed installation, refer to the "GearWall
■
Options" section for ideas.
NOTE: The current trim options do not apply to masonry block or
poured concrete wall installation.
GearWall ® Trim options (purchased separately)
Interior Corner Exterior Corner
Windows and Doors

Complete Installation

1. Make sure all screws are installed.
2. Dispose of unused parts and packaging materials.
A. Level
® Trim
End Cap