Power Requirements; Electrical Installation; Install Appliance; Removing The Mounting Plate - Bosch 500 Serie Mode D'emploi

Appliance dimensions

Electrical Installation

Electrical Requirements:
a three prong grounded outlet
▯
120 V, 60 Hz, AC only
▯
20 Amp electrical supply with a fuse or a circuit
▯
breaker
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to
the requirements of the National Electric Code or the
prevailing local code for this rating. The power supply
cord and plug should be brought to a separate 20-amp
branch circuit single grounded outlet. The outlet box

Install Appliance

Removing the mounting plate

Note: To avoid possible damage to the work surface or
to the bottom of the appliance, cover the work surface.
Remove any remaining contents from the microwave
1.
oven cavity.
Note: Take into account that the front and rear
measurements of the appliance are not identical.

Power Requirements

The outlet must be properly grounded in accordance with
all applicable codes.
It can be installed anywhere inside the cabinet above the
appliance, within reach of the power cord (approx. 24 in).
should be located inside the cabinet above the appliance
(see section Location Requirements). The outlet box and
supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
The voltage used must be the same as specified on this
microwave oven. Using a higher voltage is dangerous
and may result in a fire or oven damage. Using a lower
voltage will cause slow cooking. The manufacturer is not
responsible for any damages resulting from the use of
the oven with any voltage other than specified.
Remove the screws from the mounting plate.
2.
The mounting plate will be used as the rear wall
template and for mounting.
7