Adjusting Neutral Furniture Doors; Adjustment Of The Drawer Height - steel ZS0389 Manuel D'installation

3.10 Adjusting neutral furniture doors

Proceed as described below for neutral furniture door adjustment.
Adjustment A – frontal adjustment: the door may be frontally adjusted by +2.8 mm. The oval cavity
allows for frontal hinge sliding. Upon operation being completed make sure to firmly tighten back
down the screws.
Adjustment B – vertical adjustment: loosen the two fastening screws to vertically adjust the door by
±2 mm. The oval cavities permit sliding both ways. Always make sure to tighten back down the
screws after completing the operation.
Adjustment C – side-way adjustment: hinge wing may be moved forward by appropriately acting on
the adjustment screw. The door moves with respect to the side without any risk of detachment. No
further adjustments are required.
Hinge adjustment should always be made during installation so as to ensure proper gap squaring
and alignment.

3.11 Adjustment of the drawer height

The clips of height adjustment are located in the
lower side and at the right and left ends of the
drawer.
By turning the lever A the drawer will raise of 3
mm.
30
Instructions for the installer