Mounting The Front Profile; Mounting The Splash Guard (Optional) - steel ZS0389 Manuel D'installation

Instructions for the installer
3.6

Mounting the front profile

A front profile is supplied for the Genesi series models to complement the aesthetic line.
Proceed as follows to install:
approach profile A to the assembly seat as shown in detail in drawing 1;
•
fit the profile until it comes into contact with the assembly seat, pushing it downwards so that it
•
couples with blocks B on each end of the unit (detailed drawing 2).
3.7

Mounting the splash guard (optional)

The splash guard must not be used in combination with the stainless steel splashback.
Proceed as follows to install:
rest the splash guard A on the back of the surface, making sure the holes are aligned;
•
tighten the screws B using a Phillips screwdriver.
•
Any yellowing of the steel over time, which is completely natural, in no way alters its original
characteristics. It can be removed using specific steel cleaning products.
27