Removing The Rear Panel (Only Cabinet/Furniture With Sink); Removing Pre-Cut Side Piece (Genesi / Sintesi); Mounting The Front Moulding - steel ZS0389 Manuel D'installation

3.3
To facilitate the connection to the water
supply, part of the rear panelling of the sink
cabinet can be removed, as shown in the
figure.
3.4
To facilitate the routing of pipes or cables
when connecting to the water and electric
supplies, the pre-cut piece on the side of
the unit can be removed, as shown in the
figure.
3.5
The moulding is supplied as a standard fitting with the Genesi series whereas it is available only on
request (optional) for the Sintesi series.
To assemble, proceed as follows:
•
•
•
•
26
Instructions for the installer

Removing the rear panel (only cabinet/furniture with sink)

Removing pre-cut side piece (Genesi / Sintesi)

Mounting the front moulding

tilt the unit to the rear;
align the moulding A with the mounting position as shown in the illustration;
apply the moulding until it fits into the mounting position;
pull the moulding downward so that it hooks onto the 4 pins B (two on each side) present on
the unit.