General Recommendations; Replacing The Adjustable Feet - steel ZS0389 Manuel D'installation

Instructions for the installer
3.1

General recommendations

Only qualified installers are authorised to carry out the operations described below. The
professional installer is responsible for appliance commissioning in accordance with
prevailing standards and requirements under law. Always remember to remove plastic
protections before using the appliance.
The manufacturer declines any responsibility for damage incurred by persons, animals or
objects that is caused by not following the above guidelines (cfr. chapter " 1. Warnings for
safety and use").
3.2

Replacing the adjustable feet

The unit comes with standard feet, already installed.
The standard feet allow you to adjust the height so that you can level the unit to the floor; the unit
becomes unstable if you unscrew them too much.
To raise the unit, you should replace the standard feet with higher ones (supplied with some
models or ordered from your retailer) for an extra 3 cm but, should this not be enough for your
requirements, you can add another kit from your retailer to raise it even more.
Proceed in either of the following ways to
replace the feet:
A
By lifting the unit from the ground.
B
By setting down the unit on its back.
Remove the feet from the packing and screw
them to the bottom of the unit.
Make the final adjustment of the feet, to
level the unit to the floor, after completing
the connections, if necessary.
Should you need to drag the unit, tighten the feet all the way and then adjust them after
placing it where expected.
25