Rega brio Mode D'emploi page 5

Setting up
The Brio will work well on most surfaces, such as a shelf or table, provided there is sufficient air around the
amplifier to prevent overheating. If using a turntable, magnetic interference can be avoided by positioning
the amplifier as far away from the cartridge as the tonearm lead will allow. It is recommended not to stack
other hi-fi equipment directly on top of the amplifier. Never place it on fabric or carpet.
Connectivity
All line level inputs and outputs are made via RCA (phono) connectors.
Phono
1
Inputs
1. Phono stage input 2-5. Line level input
Line inputs enable the
This input is a phono
stage that can be used
with moving magnet
(MM) or specifically
high output moving
coil (MC) cartridges.
disabled when input 5
Earthing
The Brio is fully earthed, but you may need to earth your turntable via the tonearm. For Rega turntables,
earthing is achieved via the Phono lead ground therefore a separate earth is not necessary. If your tonearm
has a separate earth lead it will need to be connected to the earthing nut located on the underside of the
amplifier. You can use the nut to clamp down onto the earthing wire, but ensure that the turntable and Brio
are as far away as possible whilst ensuring the safety of both products.
WARNING: CASE CAN GET HOT.
2 3 4
6. Record output
For connection to any
connection of any recordable device. The
additional sources output is a 'record
such as CD players, signal' as selected by
BluRay players, the main input selector
streamers etc. Note 1-4. This output is not
the record output is affected by the volume
is selected.
English
Record
LEFT
output
5 6
Speakers
RIGHT
Earthing nut
For earthing tonearms,
located on bottom of
control.
3
Power
Fuse
Loudspeaker output
Top row: Left speaker
Red and Black.
Brio. Bottom row: Right
speaker Red and Black.